Abstract
Abrasive wear at high temperatures (HT) is a serious issue in many industrial applications. Within this work, on the example of an iron ore sinter plant, maintenance tasks were analysed and abrasive wear was found to be the most frequent tribological failure. Core components like the grate bars of the sinter belt, the sinter crusher system and the hot sieve suffer from abrasion at HT, with various forms of abrasion present. Failure analysis pointed out that high-stress abrasion, impact-abrasion and erosion are of major concern, hence these abrasion modes were studied in detail at temperatures up to 550°C-700°C. The influence of the various forms of abrasion on prospective HT wear-resistant materials was investigated. Relative soft cast materials with low amount of hardphases (40 %) and high hardness at application temperature are necessary to withstand impact-abrasion, because low hardphase containing materials showed up to 17× higher wear loss. MML formation is strongly dependent on the microstructure of the material: hardfacings with more than 40 % hardphases do not show significant MML formation. Temperature-induced material softening and severe abrasive contact encourage massive MML formation on low hardphase containing materials. In this case, wear protection of in-situ formation of MML was pronounced at HT. Linear correlation of abrasive wear rates with hot hardness was especially evident at high-stress abrasion and oblique erosion (30°). Further, the ratio of normal and oblique erosion follows a linear relationship with the hot hardness for nearly all materials and temperatures investigated.
Translated title of the contribution | Hochtemperatur-Abrasion in Sinteranlagen und deren wirtschaftlicher Verschleißschutz |
---|---|
Original language | English |
Qualification | Dr.mont. |
Supervisors/Advisors |
|
Publication status | Published - 2016 |
Bibliographical note
embargoed until nullKeywords
- tribology
- abrasion
- high temperature
- hardfacing
- sinter plant
- maintenance